Audi A4

since 1994 of release

Repair and car operation



A4 Audi
+ Running gear
+ Regular servicing
+ Engines
+ Turbo-supercharging
+ exhaust System
+ cooling System
+ Fuel tank and fuel pump
+ Air filter and absorption channels
+ injection System
+ Coupling
+ Transmission and main transfer
+ Suspension bracket of wheels and steering
+ Brakes
+ Wheels and tires
+ Electrotechnical equipment
+ ignition System
+ Lighting
+ Alarm equipment
+ Tools and devices
+ Heating and ventilation
- Body details
   Front bumper
   Damages to result of failures
   Face-to-face part of the car
   Cowl
   Wings
   Lateral levels
   Doors
   Dismantling of doors
   Mirror of the external review
   Trunk lid
   Rear bumper
   Sliding/demountable roof
   Check of a corrosion-resistant coating of the bottom
   Pro-cleaning of openings for a water drain
+ Salon
Search of malfunctions
Technical characteristics





Front bumper

After weakening of the screw (3) it is possible to extend a detail of a lattice (2) of lateral shtekerny connections (arrow). On a fixing bolt of a bumper the natural by an internal shestigrannik of 6 mm (1) is established.


To take out lateral faces of a bumper from body arms, it is necessary to wring out in the beginning a bumper down and then to pull aside.

Dismantle

 PERFORMANCE ORDER

  1. Dismantle the bottom facing of an impellent compartment.
  2. Unscrew on one screw with crosswise heads in small details of a lattice on the right and at the left below in a bumper. Take out from clips a lattice and remove it.
  3. Under details of a lattice is on one bolt with a six-sided head on 6 mm. Unscrew.
  4. Unscrew behind at a bumper in cut for a wheel on the right and at the left on one bolt of TORX.
  5. Take out lateral faces of a bumper from an arm on a wing. For this purpose wring out a bumper sideways down and at the same time pull it from a body.
  6. Wring out the bumper ends over bowls of wheel niches and remove forward.
  7. Now it is possible to pull a bumper forward.
  8. Cars with system of clarification of headlights: remove hoses to sprays and supply them with jams in order that contents of a tank of washing did not flow out.
  9. The spoiler can be removed below at a bumper after dismantle of rasporny ledges on the socket on the right and at the left.

Installation

 PERFORMANCE ORDER

  1. Connect water hoses.
  2. In the beginning lift a bumper on arms.
  3. Now enter lateral faces of a bumper so that its ends did not concern a bowl of a wheel niche.
  4. In the beginning a bumper hang on bottom edge of arms on a wing. Then press a bumper from sides; the upper edge as a result of it will be included into grooves.
  5. Tighten bolts.

Bumper alignment

 PERFORMANCE ORDER

  1. After installation of a bumper check, whether the crack between headlights and a bumper is identical everywhere.
  2. But crucial importance has a crack between bottom edge of a cowl and a bumper (about 7 mm).
  3. If the crack does not correspond to norm, again dismantle a bumper and slightly turn up or down the carving plug in a bumper arm.