Audi A4

since 1994 of release

Repair and car operation



A4 Audi
+ Running gear
- Regular servicing
   Installation in a starting position of the indicator of periodicity of maintenance
   Crossing of dates of maintenance
   The maintenance plan for the motorist
   Diagnostics in Audi workshop
   Diagnostics of an executive element
   Poll of a database of malfunctions
   Diagnostics as the help to the fan
   Car identification
   Safety measures on a workplace
   Jacks
   Greasing of all details
   Check of level of oil
   Consumption of oil
   Oil choice with the correct specification
   Viscosity of oil
   Correctly picked up engine oil for Audi
   Replacement of engine oil and oil filter
   Check of level of liquid in servoupravleniye system
   Check of level of oil in a mechanical transmission
   Check of level of oil in a drive of the back bridge
   Control of level of ATF in an automatic transmission
   Check of level of oil in the main transfer of an automatic transmission
   ATF replacement
   Greasing of drafts, hinges and locks
+ Engines
+ Turbo-supercharging
+ exhaust System
+ cooling System
+ Fuel tank and fuel pump
+ Air filter and absorption channels
+ injection System
+ Coupling
+ Transmission and main transfer
+ Suspension bracket of wheels and steering
+ Brakes
+ Wheels and tires
+ Electrotechnical equipment
+ ignition System
+ Lighting
+ Alarm equipment
+ Tools and devices
+ Heating and ventilation
+ body Details
+ Salon
Search of malfunctions
Technical characteristics





Replacement of engine oil and oil filter

Carving stopper of a masloslivny opening (3) – in the photo the six-cylinder engine is shown – becomes the bottom facing of an impellent compartment available after dismantle. For its unscrewing by the most suitable tool the cap key is. The oil filter (1) is best of all for unscrewing a tape key (on an arrow). Further in the photo are shown an oil radiator on which cooling liquid (2) flows.


 PERFORMANCE ORDER

  1. Change oil only at the warm engine! Therefore, whenever possible, do a bit of traveling on the car.
  2. Raise Audi A4 horizontally (put an emphasis!) or establish it on a ramp.
  3. Dismantle the bottom cover of an impellent compartment.
  4. Put under an engine case suitable capacity.
  5. Unscrew a cap key a carving stopper of a drain opening; let's flow down to oil. Be careful, it is hotter.
  6. If you raised the car only in front to merge the fulfilled oil completely, it needs to be merged once again. Track thus not to damage or to overturn reception capacity.
  7. Put reception capacity under the oil filter.
  8. Weaken the oil filter a tape key. If the filter sits very strongly, pierce its metal case a sharp screw-driver (be careful, hot oil follows) and unscrew the filter by means of a screw-driver.
  9. Slightly grease with componental greasing a sealing ring of the new oil filter.
  10. Do not use for this purpose lubricant oil as at visual survey it wrongly can be accepted for following engine oil.
  11. Strong screw up the filter manually, without using any tools.
  12. To Ototrita clean a screw stopper of a drain opening also screw up with a new sealing ring; but it is not too strong, differently damage directing carving on a case.
  13. Fill in oil (see the table).
  14. Get the engine, check tightness of oil.

Refueling volumes of oil

The engine with working volume
Engine oil
1,6 l
1,8 l
Six-cylinder engine
Refueling volume of oil * without replacement of the oil filter
about 2,7 l
about 3,4 l
about 4,5 l
Refueling volume of oil with filter replacement
about 3,3 l
about 3,9 l
about 5,0 l

* Only at oil replacement between maintenance intervals.